Lumenier TX5GA 5.8GHz Adjustable RF Power (25-600mw) FPV Transmitter

4277

New product

The Lumenier TX5GA Adjustable RF Power (25 - 600mW) 5.8GHz 32CH FPV video transmitter is the ultimate FPV VTX giving you the option to adjust output power to fit your needs.

More details

Out of Stock - Backordering Allowed

$49.99

Add to wishlist

More info

Details

The Lumenier TX5GA Adjustable RF Power (25 - 600mW) 5.8GHz 32CH FPV video transmitter is the ultimate FPV VTX giving you the option to adjust output power to fit your needs. This transmitter features the ability to adjust the transmission power, from 25mW, 200mW, or 600mW for long range. The lower 25mW and 200mW transmission power means more pilots can fly together without overpowering each other on close frequencies. The TX5GA has 32 channels and now includes the new Raceband frequencies. Our friends from ImmersionRC first divided the 5.8 band into 8 channels evenly spread out 37MHz from each other, which allows more racers flying at the same time on the same band. Lumenier Raceband transmitters are fully compatible with FatShark and ImmersionRC receivers.

The TX5GA features an easy to use single button, LED interface. It also comes with a clean pre-wired harness, and only weighs 12g. It’s perfect for a wide range of aircraft!

Note: The metal housing acts as a heatsink and dissipates heat, mount in an area where there is good airflow. Do not power on the transmitter for long periods of time on the ground while on 600Mw mode without active cooling as the transmitter may overheat.

Features

  • 32 channels: Cover F, E, A bands and R (Raceband) bands
  • Intuitive and easy to use button and LEDs for frequency and power selection
  • Small sized and light weight
  • Transmitter frequency: 5658-5925MHz with 25 - 600mW power output
  • Transmitting distance > ~2000m (open area at 600mW)
  • SMA Antenna connector
  • Dimensions: 38*28*9mm (not including SMA adapter or 5mm heatsink)

Specifications


Operating Voltage:

7 - 19V


Output Voltage:

5v


Supply current:

~220 mA


Operating Temperature:

-10 +85 C


Video Band Width:

0-8.0 MHz


Audio carrier Frequency:

6.5 MHz


Video Input Level:

0.8,1.0,1.2 Vp-p


Video Input Impedance:

75 Ohm


Audio Input Level:

0.5 ,2.0 Vp-p


Audio Input Impedance:

10K Ohm


Weight:

12g (without antenna)


Antenna Connector:

SMA Female Connector


Video Format:

NTSC/PAL


Output Impedance:

50 Ohm


Output Power:

26, 26.5, 27 dBm


Frequency Selection:

Single push to change CH, push and hold for 2 seconds to change FR


RF Power Selection:

Press the PWR button once to change the output RF Power.

Included

  • 1x transmitting unit (VTX) TX5GA
  • 1x antennas (2db)
  • 1x Heat Sink with 3M adhesive
  • 1x power/ video cable

*Note: TX antenna must be installed properly before it is switched on, power on without install antenna, or a improper antenna was used may easily burn the TX, and such damage is not covered by warranty. Mount the VTX in an area with good air cooling. It's recommended to apply the included heatsink when using the transmitter in 600mW mode.